Original file

Audi R8 Bosch MED17.1.1 4S0907552AL / 4S0907552AL

An original (stock) flash read of the Bosch MED17.1.1 control unit, fitted in Audi R8, hardware number 4S0907552AL and software number 4S0907552AL, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Audi R85.2 610PS
Control unit
Bosch MED17.1.1
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
4S0907552AL
Software number
4S0907552AL
Bosch part / software
10SW061943
Vehicle maker's hardware number
4S0907552R

Technical data

Vehicle
BrandAudi
Car modelR8
Engine5.2 610PS
FuelDiesel
Control unit
Control unitBosch MED17.1.1
ECU makerBosch
Hardware number4S0907552AL
Software number4S0907552AL
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key47a88ea0aa94ff0f
Identification read from the file
ECU nameMED17.1.1
Read typeFull read (boot area included)
Bosch part / software10SW061943Offset in the file: 0x38001A
Vehicle maker's hardware number4S0907552ROffset in the file: 0x3D2C0E
Software / calibration4S0907552AL · version 0001Offset in the file: 0x3D2C28
Bosch project identifier (EPK)37/1/MED17/5///D1711A20A000_MY21Q2///Offset in the file: 0x3FBF08

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17.1.1 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 4S0907552AL and software number 4S0907552AL. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17.1.1

Bosch MED17.1.1 original files

The Bosch MED17.1.1 unit page