Original file

Mercedes-Benz C200 Bosch MED17.7 MED41-18A-SER_043_00-STAR23- / 10SW026750

An original (stock) flash read of the Bosch MED17.7 control unit, fitted in Mercedes-Benz C200, hardware number MED41-18A-SER_043_00-STAR23- and software number 10SW026750, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz C2001.5 petrol 184PS
Control unit
Bosch MED17.7
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
MED41-18A-SER_043_00-STAR23-
Software number
10SW026750
Bosch part / software
10SW039856
Software / calibration
2649023500

Technical data

Vehicle
BrandMercedes-Benz
Car modelC200
Engine1.5 petrol 184PS
Power184.0PS / 135.3kW
Control unit
Control unitBosch MED17.7
ECU makerBosch
Hardware numberMED41-18A-SER_043_00-STAR23-
Software number10SW026750
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key11fec4e69e737ba5
Identification read from the file
ECU nameMED17.7
Read typeFull read (boot area included)
ProcessorTC1793
Bosch part / software10SW039856Offset in the file: 0x02001A
Software / calibration2649023500Offset in the file: 0x020213
Data set number2649039500Offset in the file: 0x3BB5C1
Boot software2649040300Offset in the file: 0x00FC4D
Internal build string001_5.10.00_CFG13;0Offset in the file: 0x00FC24
Bosch project identifier (EPK)36/1/MED17/3///D177_4A2_18A043S03///Offset in the file: 0x3FDF08

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17.7 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MED41-18A-SER_043_00-STAR23- and software number 10SW026750. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17.7

Bosch MED17.7 original files