Original file

Honda Civic Bosch MED17.9.3 10SW05009893B4V210 / 05009893

An original (stock) flash read of the Bosch MED17.9.3 control unit, fitted in Honda Civic, hardware number 10SW05009893B4V210 and software number 05009893, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Honda Civic1.0 · 122.0PS / 89.7kW
Control unit
Bosch MED17.9.3
Read type
OBD read (no boot area)
File
4,096.00 KB · Flash
Hardware number
10SW05009893B4V210
Software number
05009893
Bosch part / software
10SW050098
Software / calibration
HON1793B4_5AYW_V210A_TPROT

Technical data

Vehicle
BrandHonda
Car modelCivic
Engine1.0
FuelPetrol
Power122.0PS / 89.7kW
Control unit
Control unitBosch MED17.9.3
ECU makerBosch
Hardware number10SW05009893B4V210
Software number05009893
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keyc4a935ffde7e9344
Identification read from the file
ECU nameMED17.9.3
Read typeOBD read (no boot area)
ProcessorTC1793
Bosch part / software10SW050098Offset in the file: 0x02001A
Software / calibrationHON1793B4_5AYW_V210A_TPROTOffset in the file: 0x1FFE0C
Internal build stringPCFG:CB/159_1793_1.0.0Offset in the file: 0x00EC5C
Bosch project identifier (EPK)55/1/MED1793/159/MED1793//HON1793B4_5AYW_V210A_TPROT///Offset in the file: 0x1FFE0C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17.9.3 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 10SW05009893B4V210 and software number 05009893. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17.9.3

Bosch MED17.9.3 original files

The Bosch MED17.9.3 unit page