Original file

Suzuki SX4 Bosch MED17.9.63 0091117963 / 10SW009111

An original (stock) flash read of the Bosch MED17.9.63 control unit, fitted in Suzuki SX4, hardware number 0091117963 and software number 10SW009111, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Suzuki SX41.4 · 140.0PS / 103.0kW
Control unit
Bosch MED17.9.63
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
0091117963
Software number
10SW009111
Vehicle maker's hardware number
33920-68M0
Software / calibration
MED17963_B4_0S340A_10A

Technical data

Vehicle
BrandSuzuki
Car modelSX4
Engine1.4
FuelPetrol
Power140.0PS / 103.0kW
Control unit
Control unitBosch MED17.9.63
ECU makerBosch
Hardware number0091117963
Software number10SW009111
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key2d13d3effc94fb04
Identification read from the file
ECU nameMED17.9.63
Read typeCalibration only (data set)
Bosch part / software10SW009111Offset in the file: 0x02001A
Vehicle maker's hardware number33920-68M0Offset in the file: 0x037352
Software / calibrationMED17963_B4_0S340A_10AOffset in the file: 0x1FFE0C
Bosch project identifier (EPK)53/1/MED17963/248/MED17963//MED17963_B4_0S340A_10A///Offset in the file: 0x1FFE0C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17.9.63 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0091117963 and software number 10SW009111. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17.9.63

Bosch MED17.9.63 original files

The Bosch MED17.9.63 unit page