Original file

Ford Focus 1.0 EcoBoost Bosch MED17 FN15-14C204-PB / FN15-14C204-PB

An original (stock) flash read of the Bosch MED17 control unit, fitted in Ford Focus 1.0 EcoBoost, hardware number FN15-14C204-PB and software number FN15-14C204-PB, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Focus 1.0 EcoBoost1.0 petrol 125PS
Control unit
Bosch MED17
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
FN15-14C204-PB
Software number
FN15-14C204-PB
Bosch part / software
10SW010810
Vehicle maker's hardware number
FN15-12A650-PB

Technical data

Vehicle
BrandFord
Car modelFocus 1.0 EcoBoost
Engine1.0 petrol 125PS
Control unit
Control unitBosch MED17
ECU makerBosch
Hardware numberFN15-14C204-PB
Software numberFN15-14C204-PB
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key404027de159c5317
Identification read from the file
ECU nameMED17.0.1
Read typeCalibration only (data set)
Bosch part / software10SW010810Offset in the file: 0x04001A
Vehicle maker's hardware numberFN15-12A650-PBOffset in the file: 0x067B2A
Software / calibrationFN15-14C204-PBOffset in the file: 0x067B06
Bosch project identifier (EPK)56/1/MED17/2/FOXGTDI//D1701_002_142G_1401/160714/103346/Offset in the file: 0x07FF08

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number FN15-14C204-PB and software number FN15-14C204-PB. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17

Bosch MED17 original files