Original file

BMW 5er Bosch MEVD17.2.6 O_CL2 / 10SW016887

An original (stock) flash read of the Bosch MEVD17.2.6 control unit, fitted in BMW 5er, hardware number O_CL2 and software number 10SW016887, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW 5er3.0 petrol 305PS
Control unit
Bosch MEVD17.2.6
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
O_CL2
Software number
10SW016887
Software / calibration
75P9EL0B / 9ELHBEX1

Technical data

Vehicle
BrandBMW
Car model5er
Engine3.0 petrol 305PS
Power305.9PS / 225.0kW
Control unit
Control unitBosch MEVD17.2.6
ECU makerBosch
Hardware numberO_CL2
Software number10SW016887
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key9b70651af4c28de0
Identification read from the file
ECU nameMEVD17.2.6
Read typeFull read (boot area included)
Bosch part / software10SW016887Offset in the file: 0x18001A
Software / calibration75P9EL0B / 9ELHBEX1Offset in the file: 0x1FFE01
Data set descriptionMEVD17.2.6-N55-M0-B30-F010-ULEV2-MSA2-_HG-AG-LL-RL-PVL-BHDP
Bosch project identifier (EPK)43/1/MEVD/11/MEVD1726_75P9EL0B//75P9EL0B///Offset in the file: 0x1FFB0C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MEVD17.2.6 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number O_CL2 and software number 10SW016887. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MEVD17.2.6

Bosch MEVD17.2.6 original files

The Bosch MEVD17.2.6 unit page