Original file

BMW X5 X5-40e Bosch MEVD17.2.9 92I9FA0B#9FAKHHX6 / 9FAKHHX6

An original (stock) flash read of the Bosch MEVD17.2.9 control unit, fitted in BMW X5 X5-40e, hardware number 92I9FA0B#9FAKHHX6 and software number 9FAKHHX6, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW X5 X5-40epetrol 313PS
Control unit
Bosch MEVD17.2.9
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
92I9FA0B#9FAKHHX6
Software number
9FAKHHX6
Bosch part / software
10SW014671
Software / calibration
92I9FA0B / 9FAKHHX6

Technical data

Vehicle
BrandBMW
Car modelX5 X5-40e
Enginepetrol 313PS
Displacement2.0
Control unit
Control unitBosch MEVD17.2.9
ECU makerBosch
Hardware number92I9FA0B#9FAKHHX6
Software number9FAKHHX6
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key9d46d5f5dc610974
Identification read from the file
ECU nameMEVD17.2.9
Read typeFull read (boot area included)
Bosch part / software10SW014671Offset in the file: 0x18001A
Software / calibration92I9FA0B / 9FAKHHX6Offset in the file: 0x1FFE01
Data set descriptionMEVD17.2.U-N20-Gen3-0-Mo-B20-O0-F015--_ULEV2-HGAG-LL-RL-AWD
Bosch project identifier (EPK)43/1/MEVD/11/MEVD1729_92I9FA0B//92I9FA0B///Offset in the file: 0x1FFB0C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MEVD17.2.9 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 92I9FA0B#9FAKHHX6 and software number 9FAKHHX6. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MEVD17.2.9

Bosch MEVD17.2.9 original files

The Bosch MEVD17.2.9 unit page