Original file

BMW X4 Bosch MEVD17.2.G 0170623013 / 75Q9K10B#9K1JTSX0

An original (stock) flash read of the Bosch MEVD17.2.G control unit, fitted in BMW X4, hardware number 0170623013 and software number 75Q9K10B#9K1JTSX0, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW X4N55B30 · 360.0PS / 264.8kW
Control unit
Bosch MEVD17.2.G
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
0170623013
Software number
75Q9K10B#9K1JTSX0
Bosch part / software
10SW050207
Software / calibration
75Q9K10B / 9K1JTSX0

Technical data

Vehicle
BrandBMW
Car modelX4
EngineN55B30
FuelPetrol
Displacement3.0
Power360.0PS / 264.8kW
Control unit
Control unitBosch MEVD17.2.G
ECU makerBosch
Hardware number0170623013
Software number75Q9K10B#9K1JTSX0
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keyc1d293a93888804f
Identification read from the file
ECU nameMEVD17.2.G
Read typeFull read (boot area included)
ProcessorTC1797
Bosch part / software10SW050207Offset in the file: 0x18001A
Software / calibration75Q9K10B / 9K1JTSX0Offset in the file: 0x1FFE01
Data set descriptionMEVD17.2.G-N55-T0-B30-F026-EU6-MSA2-AG_Allrad-CVO-BHDP-RAN
Internal build stringMEVD17.2.6-CB_L6C-D6.2.0_G.5.25.0Offset in the file: 0x00FDBC
Bosch project identifier (EPK)43/1/MEVD/11/MEVD172G_75Q9K10B//75Q9K10B///Offset in the file: 0x17FB0C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MEVD17.2.G whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0170623013 and software number 75Q9K10B#9K1JTSX0. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MEVD17.2.G

Bosch MEVD17.2.G original files

The Bosch MEVD17.2.G unit page