Original file

BMW X4 Bosch MEVD17.2.G 75Q9K00B#9K0JTSX5

An original (stock) flash read of the Bosch MEVD17.2.G control unit, fitted in BMW X4, software number 75Q9K00B#9K0JTSX5, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW X43.0 360PS
Control unit
Bosch MEVD17.2.G
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Software number
75Q9K00B#9K0JTSX5
Bosch part / software
10SW012948
Software / calibration
75Q9K00B / 9K0JTSX5

Technical data

Vehicle
BrandBMW
Car modelX4
Engine3.0 360PS
FuelPetrol
Control unit
Control unitBosch MEVD17.2.G
ECU makerBosch
Software number75Q9K00B#9K0JTSX5
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key205a3d4a40e25014
Identification read from the file
ECU nameMEVD17.2.G
Read typeFull read (boot area included)
Bosch part / software10SW012948Offset in the file: 0x18001A
Software / calibration75Q9K00B / 9K0JTSX5Offset in the file: 0x1FFE01
Data set descriptionMEVD17.2.G-N55-T0-B30-F026-EU6-MSA2-AG_Allrad-CVO-BHDP-RAN
Internal build stringMEVD17.2.G-CB_L6C-D6.2.0_G.5.18.1Offset in the file: 0x00FDBC
Bosch project identifier (EPK)43/1/MEVD/11/MEVD172G_75Q9K00B//75Q9K00B///Offset in the file: 0x17FB0C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MEVD17.2.G whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, software number 75Q9K00B#9K0JTSX5. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MEVD17.2.G

Bosch MEVD17.2.G original files

The Bosch MEVD17.2.G unit page