Original file

Mercedes-Benz E53 AMG Bosch MG1CP002 MRG1x_17B_FRG_046_00_Star23_xx_M256xx / 034398

An original (stock) flash read of the Bosch MG1CP002 control unit, fitted in Mercedes-Benz E53 AMG, hardware number MRG1x_17B_FRG_046_00_Star23_xx_M256xx and software number 034398, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz E53 AMG3.0 · 457.0PS / 336.1kW
Control unit
Bosch MG1CP002
File size
8,192.00 KB
Contents
Flash
Hardware number
MRG1x_17B_FRG_046_00_Star23_xx_M256xx
Software number
034398
Bosch part / software
10SW034398
Software / calibration
2569022200

Technical data

Vehicle
BrandMercedes-Benz
Car modelE53 AMG
Engine3.0
FuelPetrol
Power457.0PS / 336.1kW
Control unit
Control unitBosch MG1CP002
ECU makerBosch
Hardware numberMRG1x_17B_FRG_046_00_Star23_xx_M256xx
Software number034398
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File key8a16ae69fa992b88
Identification read from the file
ECU nameMG1CP002
Bosch part / software10SW034398Offset in the file: 0x040144
Software / calibration2569022200Offset in the file: 0x3A8BA7
Data set number2569035600Offset in the file: 0x67EC9E
Bosch project identifier (EPK)66/1/MG1CP002/1/DA_MDG1G//MRG1x_17B_FRG_046_00_Star23_xx_M256xx///Offset in the file: 0x3A8BB8

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CP002 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRG1x_17B_FRG_046_00_Star23_xx_M256xx and software number 034398. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CP002

Bosch MG1CP002 original files

The Bosch MG1CP002 unit page