Original file

Mercedes-Benz GLE 45AMG Bosch MG1CP002 MRG1x_18A_FRG_042_00_Star23_xx_M256xx / 044314

An original (stock) flash read of the Bosch MG1CP002 control unit, fitted in Mercedes-Benz GLE 45AMG, hardware number MRG1x_18A_FRG_042_00_Star23_xx_M256xx and software number 044314, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLE 45AMG3.0 · 367.0PS / 269.9kW
Control unit
Bosch MG1CP002
File size
8,192.00 KB
Contents
Flash
Hardware number
MRG1x_18A_FRG_042_00_Star23_xx_M256xx
Software number
044314
Bosch part / software
10SW037594
Software / calibration
2569021700

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLE 45AMG
Engine3.0
FuelPetrol
Power367.0PS / 269.9kW
Control unit
Control unitBosch MG1CP002
ECU makerBosch
Hardware numberMRG1x_18A_FRG_042_00_Star23_xx_M256xx
Software number044314
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File key12eec4be6ace7644
Identification read from the file
ECU nameMG1CP002
Bosch part / software10SW037594Offset in the file: 0x040144
Software / calibration2569021700Offset in the file: 0x3B9CC7
Data set number2569035900Offset in the file: 0x680C5C
Bosch project identifier (EPK)66/1/MG1CP002/1/DA_MDG1G//MRG1x_18A_FRG_042_00_Star23_xx_M256xx///Offset in the file: 0x3B9CD8

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CP002 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRG1x_18A_FRG_042_00_Star23_xx_M256xx and software number 044314. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CP002

Bosch MG1CP002 original files

The Bosch MG1CP002 unit page