Original file

Mercedes-Benz E Bosch MG1CP002 MRG1x-18A-SER_042_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx / 10SW044283

An original (stock) flash read of the Bosch MG1CP002 control unit, fitted in Mercedes-Benz E, hardware number MRG1x-18A-SER_042_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx and software number 10SW044283, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Epetrol 435HP
Control unit
Bosch MG1CP002
File size
2,048.00 KB
Contents
Flash
Hardware number
MRG1x-18A-SER_042_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx
Software number
10SW044283

Technical data

Vehicle
BrandMercedes-Benz
Car modelE
Enginepetrol 435HP
Displacement3.0
Control unit
Control unitBosch MG1CP002
ECU makerBosch
Hardware numberMRG1x-18A-SER_042_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx
Software number10SW044283
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key9e9d5045882f325c
Identification read from the file
ECU nameMG1CP002
Bosch part / software10SW044283Offset in the file: 0x000144
Data set number2569036100Offset in the file: 0x040C5C
Bosch project identifier (EPK)66/1/MG1CP002/1/DA_MDG1G//MRG1x_18A_FRG_042_00_Star23_xx_M256xx///Offset in the file: 0x17FA7C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CP002 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRG1x-18A-SER_042_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx and software number 10SW044283. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CP002

Bosch MG1CP002 original files

The Bosch MG1CP002 unit page