Original file

Mercedes-Benz GT Bosch MG1CP002 MRG1x-18A-SER_043_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx / 10SW047716

An original (stock) flash read of the Bosch MG1CP002 control unit, fitted in Mercedes-Benz GT, hardware number MRG1x-18A-SER_043_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx and software number 10SW047716, 7,680.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GT4.0 petrol 367PS
Control unit
Bosch MG1CP002
File size
7,680.00 KB
Contents
Flash
Hardware number
MRG1x-18A-SER_043_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx
Software number
10SW047716

Technical data

Vehicle
BrandMercedes-Benz
Car modelGT
Engine4.0 petrol 367PS
Power367.0PS / 270.0kW
Control unit
Control unitBosch MG1CP002
ECU makerBosch
Hardware numberMRG1x-18A-SER_043_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx
Software number10SW047716
File
File typeOriginal flash read
File size7,680.00 KB (7,864,320 bytes)
File key6bafa7d1e821596a
Identification read from the file
ECU nameMG1CP002
Bosch part / software10SW047716Offset in the file: 0x600144
Data set number2569037300Offset in the file: 0x640C68
Bosch project identifier (EPK)66/1/MG1CP002/1/DA_MDG1G//MRG1x_18A_FRG_043_00_Star23_xx_M256xx///Offset in the file: 0x77FA7C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CP002 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRG1x-18A-SER_043_00-Star23-xx-M256xx-DEH30-SExxx-EAbxx-Axxx and software number 10SW047716. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CP002

Bosch MG1CP002 original files

The Bosch MG1CP002 unit page