Original file

Mercedes-Benz AMG GT 4-door Coupe Bosch MG1CP002 RBA4CA5F4933C9F13E4C / 10SW048174

An original (stock) flash read of the Bosch MG1CP002 control unit, fitted in Mercedes-Benz AMG GT 4-door Coupe, hardware number RBA4CA5F4933C9F13E4C and software number 10SW048174, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz AMG GT 4-door Coupepetrol · 434.9PS / 319.9kW
Control unit
Bosch MG1CP002
File size
8,192.00 KB
Contents
Flash
Hardware number
RBA4CA5F4933C9F13E4C
Software number
10SW048174
Software / calibration
2569022400

Technical data

Vehicle
BrandMercedes-Benz
Car modelAMG GT 4-door Coupe
Enginepetrol
Displacement4.0
Power434.9PS / 319.9kW
Control unit
Control unitBosch MG1CP002
ECU makerBosch
Hardware numberRBA4CA5F4933C9F13E4C
Software number10SW048174
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File key2c0c189b8f0fbff4
Identification read from the file
ECU nameMG1CP002
Bosch part / software10SW048174Offset in the file: 0x040144
Software / calibration2569022400Offset in the file: 0x3C5DE7
Data set number2569037900Offset in the file: 0x6856C2
Bosch project identifier (EPK)66/1/MG1CP002/1/DA_MDG1G//MRG1xx_18B_FRG_043_00_PT3xxx_x_M256xx///Offset in the file: 0x3C5DF8

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CP002 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number RBA4CA5F4933C9F13E4C and software number 10SW048174. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CP002

Bosch MG1CP002 original files

The Bosch MG1CP002 unit page