Original file

BMW 4er 440i Bosch MG1CS003 #EPST:R1C9J8B3B / #R1C9J8B3BCFFX0

An original (stock) flash read of the Bosch MG1CS003 control unit, fitted in BMW 4er 440i, hardware number #EPST:R1C9J8B3B and software number #R1C9J8B3BCFFX0, 16,384.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW 4er 440ipetrol 326.0PS / 239.8kW
Control unit
Bosch MG1CS003
File size
16,384.00 KB
Contents
Flash
Hardware number
#EPST:R1C9J8B3B
Software number
#R1C9J8B3BCFFX0
Bosch part / software
10SW002833

Technical data

Vehicle
BrandBMW
Car model4er 440i
Enginepetrol 326.0PS / 239.8kW
Displacement3.0
Control unit
Control unitBosch MG1CS003
ECU makerBosch
Hardware number#EPST:R1C9J8B3B
Software number#R1C9J8B3BCFFX0
File
File typeOriginal flash read
File size16,384.00 KB (16,777,216 bytes)
File keyc73194abc6017e11
Identification read from the file
ECU nameMG1CS003
Bosch part / software10SW002833Offset in the file: 0x080164
Bosch project identifier (EPK)53/1/MG1CS003/11/MG1CS003_BX8_R1C2J8B3B//R1C2J8B3B///Offset in the file: 0x10D768

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CS003 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number #EPST:R1C9J8B3B and software number #R1C9J8B3BCFFX0. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CS003

Bosch MG1CS003 original files

The Bosch MG1CS003 unit page