Original file

Ford Raptor Bosch MG1CS015 HL3A-12B684-AYB / KL3A-14C204-AED

An original (stock) flash read of the Bosch MG1CS015 control unit, fitted in Ford Raptor, hardware number HL3A-12B684-AYB and software number KL3A-14C204-AED, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Raptor3.5 380PS
Control unit
Bosch MG1CS015
File size
8,192.00 KB
Contents
Flash
Hardware number
HL3A-12B684-AYB
Software number
KL3A-14C204-AED
Bosch part / software
10SW019700
Vehicle maker's hardware number
JL3A-12A650-APA

Technical data

Vehicle
BrandFord
Car modelRaptor
Engine3.5 380PS
FuelPetrol
Control unit
Control unitBosch MG1CS015
ECU makerBosch
Hardware numberHL3A-12B684-AYB
Software numberKL3A-14C204-AED
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File key7f2d899161fbd617
Identification read from the file
ECU nameMG1CS015
Bosch part / software10SW019700Offset in the file: 0x01C144
Vehicle maker's hardware numberJL3A-12A650-APAOffset in the file: 0x037030
Software / calibrationHL3A-12B684-AYBOffset in the file: 0x037000
Engine descriptionKL3A-14C204-AEDOffset in the file: 0x3FFE4B
Bosch project identifier (EPK)57/1/MG1CS015/22/MG1CS015_E3AA0//MG1CS015_E3AA10_12060///Offset in the file: 0x081200

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CS015 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number HL3A-12B684-AYB and software number KL3A-14C204-AED. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CS015

Bosch MG1CS015 original files

The Bosch MG1CS015 unit page