Original file

Ford Mustang 2.3 STCI Bosch MG1CS017 JR3A-12B684-HA / JR3AAZE

An original (stock) flash read of the Bosch MG1CS017 control unit, fitted in Ford Mustang 2.3 STCI, hardware number JR3A-12B684-HA and software number JR3AAZE, 8,576.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Mustang 2.3 STCI2.3 petrol 290.0PS / 213.3kW
Control unit
Bosch MG1CS017
File size
8,576.00 KB
Contents
Flash
Hardware number
JR3A-12B684-HA
Software number
JR3AAZE
Bosch part / software
10SW021459
Vehicle maker's hardware number
JR3A-12A650-APA

Technical data

Vehicle
BrandFord
Car modelMustang 2.3 STCI
Engine2.3 petrol 290.0PS / 213.3kW
Control unit
Control unitBosch MG1CS017
ECU makerBosch
Hardware numberJR3A-12B684-HA
Software numberJR3AAZE
File
File typeOriginal flash read
File size8,576.00 KB (8,781,824 bytes)
File keyf59fe44f57a812a6
Identification read from the file
ECU nameMG1CS017
Bosch part / software10SW021459Offset in the file: 0x01C144
Vehicle maker's hardware numberJR3A-12A650-APAOffset in the file: 0x037030
Software / calibrationJR3A-12B684-HAOffset in the file: 0x037000
Engine descriptionJR3A-14C204-AZEOffset in the file: 0x3FFE4B
Bosch project identifier (EPK)57/1/MG1CS017/22/MG1CS017_D4CA0//MG1CS017_D4CB00_12050///Offset in the file: 0x080220

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CS017 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number JR3A-12B684-HA and software number JR3AAZE. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CS017

Bosch MG1CS017 original files

The Bosch MG1CS017 unit page