Original file

Ford Edge Bosch MG1CS017 KK1A-12B684-HA / K2GA-14C204-FXD

An original (stock) flash read of the Bosch MG1CS017 control unit, fitted in Ford Edge, hardware number KK1A-12B684-HA and software number K2GA-14C204-FXD, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Edge2.0 · 245.0PS / 180.2kW
Control unit
Bosch MG1CS017
File size
8,192.00 KB
Contents
Flash
Hardware number
KK1A-12B684-HA
Software number
K2GA-14C204-FXD
Bosch part / software
10SW047522
Vehicle maker's hardware number
K2GA-12A650-CEA

Technical data

Vehicle
BrandFord
Car modelEdge
Engine2.0
FuelPetrol
Power245.0PS / 180.2kW
Control unit
Control unitBosch MG1CS017
ECU makerBosch
Hardware numberKK1A-12B684-HA
Software numberK2GA-14C204-FXD
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File key7c6da3c0c93fd0a8
Identification read from the file
ECU nameMG1CS017
Bosch part / software10SW047522Offset in the file: 0x01C144
Vehicle maker's hardware numberK2GA-12A650-CEAOffset in the file: 0x037030
Software / calibrationKK1A-12B684-HAOffset in the file: 0x037000
Engine descriptionK2GA-14C204-FXDOffset in the file: 0x3FFE4B
Bosch project identifier (EPK)57/1/MG1CS017/22/MG1CS017_D4CC0//MG1CS017_D4CC00_16051///Offset in the file: 0x080220

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CS017 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number KK1A-12B684-HA and software number K2GA-14C204-FXD. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CS017

Bosch MG1CS017 original files

The Bosch MG1CS017 unit page