Original file

Ford Transit Bosch MG1CS017 MK21-14C204-AE / 10SW081240

An original (stock) flash read of the Bosch MG1CS017 control unit, fitted in Ford Transit, hardware number MK21-14C204-AE and software number 10SW081240, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Transitpetrol
Control unit
Bosch MG1CS017
File size
8,192.00 KB
Contents
Flash
Hardware number
MK21-14C204-AE
Software number
10SW081240
Bosch part / software
10SW051589
Vehicle maker's hardware number
LK21-12A650-CC
Software / calibration
LK2T-12B684-BB

Technical data

Vehicle
BrandFord
Car modelTransit
Enginepetrol
Control unit
Control unitBosch MG1CS017
ECU makerBosch
Hardware numberMK21-14C204-AE
Software number10SW081240
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File keyecf77b3e5c5f04ed
Identification read from the file
ECU nameMG1CS017
Bosch part / software10SW051589Offset in the file: 0x010144
Vehicle maker's hardware numberLK21-12A650-CCOffset in the file: 0x037030
Software / calibrationLK2T-12B684-BBOffset in the file: 0x037000
Engine descriptionMK21-14C204-AEOffset in the file: 0x27FF4B
Bosch project identifier (EPK)58/1/MDG1/22/V362_PHEV_REX//MG1CS017_TREX_VCM167_SERIES///Offset in the file: 0x088AA8

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MG1CS017 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MK21-14C204-AE and software number 10SW081240. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MG1CS017

Bosch MG1CS017 original files

The Bosch MG1CS017 unit page