Original file
BMW X6 Bosch MG1CS201 DME88T0_35UP / 10SW044953
An original (stock) flash read of the Bosch MG1CS201 control unit, fitted in BMW X6, hardware number DME88T0_35UP and software number 10SW044953, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.
Is this your file?
Compare these numbers with the label on your control unit before you order.
- Vehicle
- BMW X64.4 petrol 599PS
- Control unit
- Bosch MG1CS201
- File size
- 8,192.00 KB
- Contents
- Flash
- Hardware number
- DME88T0_35UP
- Software number
- 10SW044953
Technical data
| Brand | BMW |
|---|---|
| Car model | X6 |
| Engine | 4.4 petrol 599PS |
| Power | 599.6PS / 441.0kW |
| Control unit | Bosch MG1CS201 |
|---|---|
| ECU maker | Bosch |
| Hardware number | DME88T0_35UP |
| Software number | 10SW044953 |
| File type | Original flash read |
|---|---|
| File size | 8,192.00 KB (8,388,608 bytes) |
| File key | 5e8b53542dc29af4 |
| ECU name | MG1CS201 | |
|---|---|---|
| Bosch part / software | 10SW044953 | Offset in the file: 0x000164 |
| Bosch project identifier (EPK) | 57/1/MG1CS201/11/MG1CS201_S63TUE4_H4C29655B//H4C29655B/// | Offset in the file: 0x6A31A0 |
About this file
Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.
In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.
How to use this file
- Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
- Open the file in your programmer, compare its numbers with your unit and check the checksum.
- Write it only to a Bosch MG1CS201 whose label carries the same hardware and software numbers.
Before you write Compare the numbers on your control unit with this file, hardware number DME88T0_35UP and software number 10SW044953. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.