Original file

Mitsubishi Colt MELCO E6T73

An original (stock) flash read of the MELCO E6T73 control unit, fitted in Mitsubishi Colt, 512.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Vehicle
Mitsubishi Colt1.5 petrol 150PS
Control unit
MELCO E6T73
File size
512.00 KB
Contents
Flash

Technical data

Vehicle
BrandMitsubishi
Car modelColt
Engine1.5 petrol 150PS
Power150.0PS / 110.3kW
Control unit
Control unitMELCO E6T73
File
File typeOriginal flash read
File size512.00 KB (524,288 bytes)
File key9e0fb70665dcf99e

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a MELCO E6T73 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of MELCO E6T73

MELCO E6T73 original files